Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Chevrolet Impala LSFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Place the ignition switch in the OFF position.
- Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
- Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
- Without draining the engine coolant and without disconnecting the hoses, remove the nuts and position aside the radiator surge tank. Refer to Radiator Surge Tank Replacement .
- Clean the area surrounding the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) mating surfaces.
- Disconnect the EBCM electrical connector.
- Remove the EBCM bolts (1).
CAUTION:
To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
