2012 Chevrolet VoltFACTORY OEM SERVICE PROCEDURE

Disc Brake Component Specifications

WARNING: This page is about a different car, the 2011 Chevrolet Volt. However, it is still accessible from the selected car via links, so may be relevant.
Application Specification
Metric English
Front Brakes
  • Brake Pad Minimum Thickness
2.0 mm 0.078 in
  • Rotor Diameter
300.0 mm 11.810 in
  • Rotor Discard Thickness*
23.0 mm 0.905 in
  • Rotor Maximum Allowable Assembled Lateral Runout
0.06 mm 0.002 in
  • Rotor Maximum Allowable Scoring
1.50 mm 0.059 in
  • Rotor Maximum Allowable Thickness Variation
0.025 mm 0.001 in
  • Rotor Minimum Allowable Thickness After Refinish
23.2 mm 0.913 in
  • Rotor Thickness New
26.0 mm 1.023 in
Rear Brakes
  • Brake Pad Minimum Thickness
2.0 mm 0.078 in
  • Rotor Diameter
292.0 mm 11.496 in
  • Rotor Discard Thickness*
10 mm 0.393 in
  • Rotor Maximum Allowable Assembled Lateral Runout
0.05 mm 0.002 in
  • Rotor Maximum Allowable Thickness Variation
0.025 mm 0.001 in
  • Rotor Maximum Allowable Scoring
1.50 mm 0.059 in
  • Rotor Minimum Allowable Thickness After Refinish
10.2 mm 0.402 in
  • Rotor Thickness New
12.0 mm 0.472 in
* All brake rotors have a minimum thickness dimension cast into them. Replace any rotor that is worn or machined below this specification.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.