2012 Chevrolet VoltFACTORY OEM SERVICE PROCEDURE

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2011 Chevrolet Volt. However, it is still accessible from the selected car via links, so may be relevant.
Application Specification
Metric English
Steering Linkage Inner Tie Rod Nut 60 N.m 44 lb ft
Front Strut to Knuckle Nuts
First Pass 85 N.m 63 lb ft
Final Pass additional 65 degrees
Rear Axle Bracket Bolts (1)
First Pass 90 N.m 66 lb ft
Final Pass additional 45 degrees
Replace Bolts (1)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.