Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet VoltFACTORY OEM SERVICE PROCEDURE
Instrument Panel Components (1 of 2)
Instrument Panel Components (1 of 2)
| Component Name | Callout |
|---|---|
| P19H Speaker - Left Front Tweeter | 1 |
| S78 Turn Signal/Multifunction Switch | 2 |
| P16 Instrument Cluster | 3 |
| P36 Battery State of Charge Indicator | 4 |
| B10B Ambient Light/Sunload Sensor | 5 |
| S82 Windshield Wiper/Washer Switch | 6 |
| P17 Info Display Module | 7 |
| S26 Hazard Warning Switch | 8 |
| P19V Speaker - Right Front Tweeter | 9 |
| A20 Radio/HVAC Controls | 10 |
| S91 Park Brake Control Switch | 11 |
| S3 Transmission Shift Lever | 12 |
| S83 Vehicle On/Off Switch | 13 |
| S126 Drive Mode Select Switch | 14 |
| S70R Steering Wheel Controls Switch - Right | 15 |
| S70L Steering Wheel Controls Switch - Left | 16 |
| S16 Driver Information Center Switch | 17 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
