Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Volt L4-1.4L ElectFACTORY OEM SERVICE PROCEDURE
Fuel Level Sensor: Locations
Wheels/Vehicle Underbody Component Views
Underbody - Fuel System Components
1 - B47 Fuel Pressure Sensor
2 - Q63 Evaporative Emission System Leak Detection Pump Assembly
3 - Q13 Evaporative Emission Vent Solenoid Valve
4 - B150 Fuel Tank Pressure Sensor
5 - B46 Fuel Level Sensor
6 - G12 Fuel Pump
7 - A7 Fuel Pump and Level Sensor Assembly
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.