Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Volt L4-1.4L ElectFACTORY OEM SERVICE PROCEDURE
HVAC Control Module
Instrument Panel/Center Console Component Views
Instrument Panel Components (2 of 2)
1 - K73 Telematics Communication Interface Control Module
2 - K33 HVAC Control Module
3 - K89 Immobilizer Control Module
4 - E32 Cigarette Lighter Receptacle
5 - B101 Immobilizer Antenna
6 - A11 Radio
7 - B22 Brake Pedal Position Sensor
8 - B201 Brake Control Brake Pedal Position Sensor
9 - F114D Knee Air Bag - Driver
10 - B107 Accelerator Pedal Position Sensor
11 - T10 Keyless Entry Antenna
12 - F114P Knee Air Bag - Passenger
13 - T15 Navigation Antenna Signal Splitter
14 - K9 Body Control Module
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.