Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Traverse LS, AWDFACTORY OEM SERVICE PROCEDURE
Fastener Specifications
WARNING: This page is about a different car, the 2015 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Driver or Passenger Seat Side Inflatable Restraint Module Nut | 9 N.m | 79 lb in |
| Driver of Passenger Seat Belt Tensioner Assembly Fastener | 45 N.m | 33 lb ft |
| Driver of Passenger Seat Belt Tensioner Fastener | 6 N.m | 53 lb in |
| Front Seat Belt Pretensioner Fastener | 42 N.m | 31 lb in |
| Inflatable Restraint Discriminating Front End Sensor | 7.5 N.m | 66 lb in |
| Inflatable Restraint Instrument Panel Module Fasteners | 10 N.m | 89 lb in |
| Inflatable Restraint Roof Rail Module Fasteners | 9 N.m | 80 lb in |
| Inflatable Restraint Seat Position Sensor Fastener | 3 N.m | 25 lb in |
| Inflatable Restraint Sensing and Diagnostic Module (SDM) Fasteners | 7 N.m | 56 lb in |
| Inflatable Restraint Side Impact Sensor Bolts | 10 N.m | 89 lb in |
| Inflatable Restraint Steering Wheel Module Coil Bolt | 3 N.m | 27 lb in |
| Seat Belt Buckle Pretensioner Bolt | 42 N.m | 31 lb ft |
| Seat Shoulder Belt Guide Fastener | 42 N.m | 31 lb ft |
| Seat Shoulder Belt Retractor Fastener | 68 N.m | 50 lb ft |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
