Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Traverse LS, AWDFACTORY OEM SERVICE PROCEDURE
Section 239 (Programming And Setup - All Systems)
WARNING: This page is about a different car, the 2015 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
- Diagnostic Information and Procedures
- Repair Instructions
- Active Safety Control Module Programming and Setup
- Audio Amplifier Programming and Setup
- Body Control Module Programming and Setup
- Control Solenoid Valve and Transmission Control Module Assembly Programming and Setup (6T70 (M7U, M7W))
- Electronic Brake Control Module Programming and Setup
- Electronic Parking Brake Control Module Programming and Setup
- K20 Engine Control Module: Programming and Setup
- Front and Rear Parking Assist Control Module Programming and Setup
- Front View Camera Module Programming and Setup
- Fuel Pump Power Control Module Programming and Setup
- Garage Door Opener Programming and Setup
- Headlamp Control Module Programming and Setup
- Heated Seat Control Module Programming and Setup
- Human Machine Interface Control Module Programming and Setup
- HVAC System Control Module Programming and Setup
- Immobilizer Control Module Programming and Setup
- Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
- Instrument Cluster Programming and Setup
- Keyless Entry Control Module Programming and Setup
- Liftgate Control Module Programming and Setup
- Radar Sensor Module - Long Range Programming and Setup
- Multi-Axis Acceleration Sensor Module Programming and Setup
- Navigation Control Module Programming and Setup
- Media Disc Player Programming and Setup
- Outside Rearview Mirror Programming and Setup
- Passenger Presence System Programming and Setup
- Radar Sensor Module - Short Range Programming and Setup
- Radio Control Programming and Setup
- Radio Programming and Setup
- Rear Differential Clutch Control Module Programming and Setup
- Rear Seat Heater Control Module Programming and Setup
- Rearview Camera Image Display Module Programming and Setup
- Remote Control Door Lock Receiver Programming and Setup
- Seat Memory Control Module Programming and Setup
- Seat Belt Retractor Motor Module Programming and Setup
- Service Programming System (SPS)
- Side Object Sensor Programming and Setup (N America)
- Side Object Sensor Programming and Setup (Except N America)
- Steering Column Lock Control Module Programming and Setup
- Steering Wheel Heat Control Module Programming and Setup
- Sunroof Control Module Programming and Setup
- Suspension Control Module Programming and Setup
- Telematics Communication Interface Control Module Programming and Setup
- Trailer Lamp Control Module Programming and Setup
- Special Tools and Equipment
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.