2012 Chevrolet Traverse FWD V6-3.6LFACTORY OEM SERVICE PROCEDURE

Power Window Switch: Testing and Inspection




Door Lock and Side Window Switch Programming and Setup

After replacing the Door Lock/Window Switch - Driver or the Door Lock/Window Switch - Passenger, perform the programming procedure. Refer to Service Programming System (SPS) Service Programming System (SPS).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.