2012 Chevrolet Traverse AWD V6-3.6LFACTORY OEM SERVICE PROCEDURE

Control Unit: Service and Repair




Rear Differential Clutch Control Module Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the propeller shaft assembly. Refer to Propeller Shaft Replacement Service and Repair.

Factory service manual diagram




3. Remove the torque tube mounting bolt.

Factory service manual diagram




Note:
DO NOT allow the torque tube to hang, support with a suit stand.

4. Lower the torque tube to gain access to the clutch control module.

Factory service manual diagram




5. Disconnect the electrical connectors from the clutch control module.

Factory service manual diagram




6. Remove the screws for the clutch control module.

7. Remove the clutch control module from the torque tube.

Installation Procedure

Factory service manual diagram




1. Position the clutch control module on the torque tube.

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the mounting screws for the clutch control module.

Tighten the screws to 8 Nm (71 lb in).

Factory service manual diagram




3. Reconnect the electrical connectors for the clutch control module.

Factory service manual diagram




4. Lift the torque back into position.

Factory service manual diagram




5. Install the torque tube mounting bolt.

Tighten the bolt to 185 Nm (137 lb ft).

6. Install the propeller shaft. Refer to Propeller Shaft Replacement Service and Repair

7. Remove the support and lower the vehicle.

8. Reprogram the clutch control module. Refer to Control Module References Programming and Relearning.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.