Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Sonic LS, 4D Hatchback, Standard TransFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Specifications
Wheel Alignment Specifications
| Suspension | Camber | Camber Cross Tolerance | Caster | Caster Cross Tolerance | Total Toe | Steering Wheel Angle | Thrust Angle |
|---|---|---|---|---|---|---|---|
| Front FE1 | -0.80°± 0.75° | 0.0°± 0.75° | 4.40° ± 0.75° | 0.00°± 0.75° | +0.10° ± 0.20° | 0.00° ± 2.50° | - |
| Front FE4 | -0.70°±0.75° | 0.0°± 0.75° | 4.35° ± 0.75° | 0.0°± 0.75° | +0.13° ± 0.20° | 0.00° ± 2.50° | - |
| Front ECO | -0.95°±0.75° | 0.0°± 0.75° | 4.55° ± 0.75° | 0.0°± 0.75° | +0.04° ± 0.20° | 0.00° ± 2.50° | - |
| Rear FE1 | -1.00° ± -0.50° | 0.00°± 0.75° | - | - | +0.40° ± 0.50° | - | 0.00° ± 0.40° |
| Rear FE4 | -1.00° ± -0.50° | 0.00°± 0.75° | - | - | +0.38° ± 0.50° | - | 0.00° ± 0.40° |
| Rear ECO | -1.00° ± -0.50° | 0.00°± 0.75° | - | - | +0.41° ± 0.50° | - | 0.00° ± 0.40° |
|
NOTE:
EC0 = LDC, M26, FV5, FE1 or LSF, M7Q, FP9, FE1 |
|||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.