Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Orlando (CANADA) L4-2.4LFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Specifications
Wheel Alignment Specifications
Table 1: Example
Table 2: Front and Rear Specifications
Note: All specifications are in degrees, convert to angular minutes, if necessary.
Conversion
^ 1.00 degree = 60 angular minutes
^ 0.75 degrees = 45 angular minutes
^ 0.50 degrees = 30 angular minutes
^ 0.25 degrees = 15 angular minutes
^ 1.00 angular minute = 60 angular seconds
Example
0.14 degrees* 60 angular minutes / degree = 8.40 angular minutes
0.40 angular / minutes* 60 angular seconds / angular minute = 24.00 angular seconds
Note: Angular seconds up to 30 are rounded off, angular seconds beyond are rounded up to 60 angular seconds.
24.00 angular seconds -> 0 angular seconds = 0.00 angular minute
0.14 degrees = 8.40 angular minutes = 8.00 angular minutes
Condition: Full tank, no passengers and placed on plane ground.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.