Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Malibu L4-2.4LFACTORY OEM SERVICE PROCEDURE
Keyless Entry Receiver: Locations
Passenger Compartment/Roof Component Views
Headliner Components
1 - E31L Sunshade Mirror Lamp - Left (DH6)
2 - A3L Sunshade - Left
3 - B24 Cellular Phone Microphone (UPH)
4 - S12 Dome Lamp Switch
5 - E37EL Dome/Reading Lamps - Front Overhead Console Left
6 - S88 Sunroof Tilt Switch (CF5)
7 - S72 Sunroof Switch (CF5)
8 - E37ER Dome/Reading Lamps - Front Overhead Console Right
9 - E37R Dome/Reading Lamps -- Rear
10 - A3R Sunshade - Right
11 - E31R Sunshade Mirror Lamp - Right (DH6)
12 - K77 Remote Control Door Lock Receiver
13 - A10 Inside Rearview Mirror
14 - B117 Rain Sensor (CE4)
15 - B160 Windshield Temperature and Inside Moisture Sensor (ASV)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.