Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Impala V6-3.6LFACTORY OEM SERVICE PROCEDURE
Rear Toe Adjustment
Rear Toe Adjustment
Note: Adjust the rear toe on each rear wheel separately.
1. Loosen the rear suspension adjust link nuts (1) and (3).
2. Adjust the toe by rotating the rear suspension adjust link (2) until the proper specification as been reached. Refer to Wheel Alignment Specifications Specifications.
Caution: Refer to Fastener Caution Fastener Caution.
3. Using a backup wrench to hold the rear suspension adjust link (2), tighten the rear suspension adjust link nuts (1) and (3) to 75 Nm (55 lb ft).
4. Recheck the toe setting.
5. If necessary, readjust the toe specifications.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.