2012 Chevrolet Express 1500 RWD V6-4.3LFACTORY OEM SERVICE PROCEDURE

Air Flow Meter/Sensor: Service and Repair




Mass Airflow Sensor with Intake Air Temperature Sensor Replacement

Removal Procedure

Factory service manual diagram




1. Loosen the air cleaner outlet duct clamp (1) at the mass airflow (MAF)/Intake air temperature (IAT) sensor.

2. Remove the air cleaner outlet duct (2) from the MAF/IAT sensor and position out of the way.

Factory service manual diagram




3. Disconnect the engine wiring harness electrical connector (6) from the MAF/IAT sensor (5).

Factory service manual diagram




4. Remove the MAF/IAT sensor bolts (2).

5. Remove the MAF/IAT sensor (1) from the air cleaner housing.

Installation Procedure

Factory service manual diagram




1. Install the MAF/IAT sensor (1) to the air cleaner housing.

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the MAF/IAT sensor bolts (2) and tighten to 9 Nm (80 lb in).

Factory service manual diagram




3. Connect the engine wiring harness electrical connector (6) to the MAF/IAT sensor (5).

Factory service manual diagram




4. Position and install the air cleaner outlet duct (2) to he MAF/IAT sensor.

5. Tighten the air cleaner outlet duct clamp (1) at the MAF/IAT sensor and tighten to 5 Nm (44 lb in).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.