2012 Chevrolet Cruze LTZFACTORY OEM SERVICE PROCEDURE

Mass Airflow Sensor Replacement

Fig 1: Mass Airflow Sensor
GM2191970Courtesy of GENERAL MOTORS COMPANY
Mass Airflow Sensor Replacement

Callout Component Name
1 Mass Air Flow Sensor Bolt (Qty: 2)
2 Mass Air Flow Sensor

Procedure

  1. Disconnect electrical connector
  2. After replacement of mass air flow sensor, use a scan tool to perform the learn functions. Refer to Engine Control Module Programming and Setup .
3 Mass Air Flow Sensor Seal Ring
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.