2012 Chevrolet Cruze LTZFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Air Cleaner Element
    GM2191545Courtesy of GENERAL MOTORS COMPANY
  1. Install the air cleaner element (3).
  2. Install the air cleaner upper housing (2) to the air cleaner lower housing (4).
  3. CAUTION:

    Refer to Fastener Caution .

  4. Install the 5 air cleaner housing bolts (1).
  5. Fig 2: Air Cleaner Housing Air Cleaner Housing, Mass Air Flow Sensor Wiring Harness Plug And Mass Air Flow Sensor
    GM2191547Courtesy of GENERAL MOTORS COMPANY
  6. Install the air cleaner outlet duct (2) to the air cleaner housing (1).
  7. Install the air cleaner outlet duct clamp (3).
  8. Fig 3: Air Cleaner Housing, Mass Air Flow Sensor Wiring Harness Plug And Mass Air Flow Sensor
    GM2191533Courtesy of GENERAL MOTORS COMPANY
  9. Clip in mass air flow sensor wiring harness retainer clip to air cleaner housing (1).
  10. Connect the mass air flow sensor wiring harness plug 2) to the mass air flow sensor (3).
  11. Close hood.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.