Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Cruze LS, Automatic TransFACTORY OEM SERVICE PROCEDURE
Battery Cable: Remove & Replace
WARNING: This page is about the Cruze Eco, Automatic Trans, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 1.4L Eng,Turbocharger,Automatic Trans, Negative | 0.7 | 0.2 | D | |
| 1.4L Eng,Turbocharger,Automatic Trans, Positive,Battery to Junction Block | 0.4 | 0.2 | D | |
| 1.4L Eng,Turbocharger,Automatic Trans, Positive,Junction Block to Starter,Generator | Includes: R&I Battery and Tray. Includes: R&I Bumper Cover. Includes: Confirm Fluid temperature for level check. | 2.5 | 0.7 | D |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.