Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Cruze L4-1.8LFACTORY OEM SERVICE PROCEDURE
Seat Temperature Control Module: Locations
Passenger Compartment/Roof Component Views
Driver Seat Components (1 of 2)
1 - M50D Seat Front Vertical Motor - Driver (ADS)
2 - K29 Seat Heating Control Module (KA1)
3 - S64D Seat Adjuster Switch - Driver (ADS)
4 - F106D Seat Air Bag - Driver
5 - F113D Seat Belt Anchor Pretensioner - Driver
6 - M55D Seat Rear Vertical Motor - Driver (ADS)
7 - M51D Seat Horizontal Motor - Driver (ADS)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.