2012 Chevrolet Corvette V8-6.2L SCFACTORY OEM SERVICE PROCEDURE

Vehicle Speed Sensor: Service and Repair




Vehicle Speed Sensor Replacement

Removal Procedure

Factory service manual diagram




1. Raise and suitably the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Clean any dirt from around the vehicle speed sensor (VSS).

3. Disconnect the electrical connector from the VSS.

Factory service manual diagram




4. Remove the bolt retaining the VSS to the rear differential case.

5. Remove the VSS from the differential case.

Installation Procedure

Factory service manual diagram




1. Lubricate the O-ring seal of the VSS with clean engine oil.

2. Install the VSS into the hole on the axle case.

Caution:
Refer to Fastener Caution Fastener Caution.

3. Install the VSS retaining bolt the differential.

Tighten the vehicle speed sensor retaining bolt to 10 Nm (89 lb in).

Factory service manual diagram




4. Connect the electrical connector to the sensor.

5. Lower the vehicle.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.