Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Corvette V8-6.2L SCFACTORY OEM SERVICE PROCEDURE
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor Replacement
Removal Procedure
1. Remove the generator bracket assembly. Refer to Generator Bracket Replacement Generator Bracket Replacement.
2. Remove the camshaft position sensor mounting bolts (1).
3. Remove the camshaft position sensor assembly (4, 5, 6) from the front cover (7).
4. Disconnect the camshaft position sensor jumper harness (2) and the engine harness (3) electrical connectors.
5. Remove the camshaft sensor assembly (4, 5, 6).
6. Disconnect camshaft position sensor (5) from the jumper harness (4).
Installation Procedure
1. Reconnect the camshaft sensor (5) and the jumper harness (4).
2. Install the O-ring (6) on the camshaft sensor assembly (4 and 5).
3. Reconnect the camshaft position sensor assembly (4, 5 and 6) and the engine harness connector (3).
Note:
Before installing the camshaft sensor assembly, apply a small amount of clean motor oil to the O-ring (6).
4. Install the camshaft position sensor assembly (4, 5 and 6) in the front cover (7).
Caution:
Refer to Fastener Caution Fastener Caution.
5. Install the camshaft position sensor mounting bolts.
Tighten the camshaft position mounting bolts 25 Nm (18 lb ft).
6. Install the generator assembly. Refer to Generator Bracket Replacement Generator Bracket Replacement.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
