Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Colorado 2WD L5-3.7LFACTORY OEM SERVICE PROCEDURE
Window Handle: Service and Repair
Door Window Regulator Handle Replacement
Tools Required
J 9886-01 Door Handle Clip Remover
Removal Procedure
1. Raise the window to the full up position.
2. Remove the window regulator handle from the door by inserting tool J 9886-01 between the handle and the white plastic washer.
3. Align the J 9886-01 with the handle.
4. Push the J 9886-01 in order to disengage the clip.
5. Pull the handle from the door.
6. Remove the window regulator handle from the door.
7. Remove the bearing plate from the door.
Installation Procedure
1. Ensure that the window is in the full up position.
2. Install the white plastic washer to the regulator shaft.
3. Install the retaining clip to the handle.
4. Install the window regulator handle to the door with the handle forward at about a 50 degree angle.
5. Push on the handle until the clip engages on the shaft.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
