Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CAPTIVA SPORT AWD L4-2.4LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSFUEL TANK PRESSURE SENSORSERVICE AND REPAIR
2012 Chevrolet Captiva Sport AWD L4-2.4L
Fuel Tank Pressure Sensor: Service and Repair
2012 Chevrolet Captiva Sport AWD L4-2.4LSECTION Service and Repair
Fuel Tank Pressure Sensor Replacement
Removal Procedure
1. Remove the fuel tank. Refer to Fuel Tank Replacement (AWD) Fuel Tank Replacement (AWD)Fuel Tank Replacement (FWD) Fuel Tank Replacement (FWD).
2. Disconnect the fuel tank wiring harness electrical connector (1) from the fuel tank pressure sensor.
3. Disengage the retaining tab (1) securing the fuel tank pressure sensor.
4. Carefully lift and remove the fuel tank pressure sensor (2) from the fuel pump module.
Installation Procedure
1. Install the fuel tank pressure sensor (2) to the fuel pump module assembly until the sensor engages the retaining tab (1).
2. Connect the fuel tank wiring harness electrical connector (1) to the fuel tank pressure sensor.
3. Install the fuel tank. Refer to Fuel Tank Replacement (AWD) Fuel Tank Replacement (AWD)Fuel Tank Replacement (FWD) Fuel Tank Replacement (FWD).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.