Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Caprice PPV V6-3.6LFACTORY OEM SERVICE PROCEDURE
Connecting Rod, Engine
Connecting Rod Bearing Clearance 0.010-0.070mm 0.0004-0.0026in
Install the connecting rod bolts into the connecting rod cap and tighten the connecting rod bolts to 30 Nm (22 lb ft).
Loosen the connecting rod bolts until the torque reading is zero.
Re-tighten the connecting rod bolts.
First Pass
Tighten the connecting rod bolts to 25 Nm (18 lb ft).
Final Pass
Tighten the connecting rod bolts an additional 110 degrees.
Install the connecting rod bolts into the connecting rod cap and tighten the connecting rod bolts to 30 Nm (22 lb ft).
Loosen the connecting rod bolts until the torque reading is zero.
Re-tighten the connecting rod bolts.
First Pass
Tighten the connecting rod bolts to 25 Nm (18 lb ft).
Final Pass
Tighten the connecting rod bolts an additional 110 degrees.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
