2012 Chevrolet Caprice PPV V6-3.6LFACTORY OEM SERVICE PROCEDURE

Service Programming System (SPS) Caution




Service Programming System (SPS) Caution

Caution:
Before programming a control module, the following must be observed, or control module damage may occur:

* The TIS terminal, MDI, and/or scan tool must have the latest software.

* The vehicle battery must be fully charged. The battery voltage should be between 12-14 volts.

* The TIS terminal, MDI, and/or scan tool cable connections must be secure.

* A battery charger must NOT be connected to the battery when programming a control module.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.