Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Caprice PPV V6-3.6LFACTORY OEM SERVICE PROCEDURE
Power Window Control Module: Service and Repair
Front Side Door Window Control Module Replacement
Removal Procedure
Warning:
Refer to Safety Glasses Warning Safety Glasses Warning.
1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).
2. Remove the closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side Instrument Panel Insulator Panel Replacement - Right Side.
3. Remove the knee bolster. Refer to Knee Bolster Replacement Service and Repair.
4. Remove the hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement Body Hinge Pillar Trim Panel Replacement.
5. Disconnect the door module electrical connector (1).
Important:
The door module is located on the right side just under the instrument panel attached to the body.
Important:
Pry the door module (1) with a suitable flat bladed tool then manoeuvre to release top locating retainer (3).
6. Pry the door module (1) with a suitable flat bladed tool to release the retainers (3).
7. Remove the door module (1) from the vehicle (2).
Installation Procedure
1. Position the door module (1) to the vehicle (2).
Important:
Locate the top retainer first then press to engage the lower retainer.
2. Install the door module (1) and push to secure the retainers (3).
3. Connect the door module electrical connector (1).
4. Install the hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement Body Hinge Pillar Trim Panel Replacement.
5. Install the knee bolster. Refer to Knee Bolster Replacement Service and Repair.
6. Install the closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side Instrument Panel Insulator Panel Replacement - Right Side.
7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).
8. If re-programming is required. Refer to Control Module References Control Module References.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
