Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Caprice PPV V6-3.6LFACTORY OEM SERVICE PROCEDURE
Body Control Module: Testing and Inspection
Body Control Module Programming and Setup
Introduction
A new body control module (BCM) must be programmed with the latest operating software and vehicle calibrations. Ensure that the following conditions exist in order to prepare for BCM programming:
* The battery is fully charged.
* The ignition switch is in the ON position.
* The data link connector (DLC) is accessible.
* All disconnected modules and devices are connected.
Programming the BCM
Note:
The vehicle will not start and many other functions may not operate correctly if a replacement BCM is not correctly set up. The following procedures must be followed:
1. The BCM reprogramming - Refer to Service Programming System (SPS) Service Programming System (SPS).
2. Brake pedal position sensor (BPPS) learn.
3. Program SDM primary key to BCM
Note:
After the procedure is completed, the personalization settings of the BCM are set to default settings. Inform the customer that the personalization must be set again.
Brake Pedal Position Sensor (BPPS) Learn
1. Calibration Criteria DO NOT apply the brake pedal during the brake pedal position sensor calibration procedure. Any movement of the brake pedal during this procedure will cause the calibration procedure to fail. If this occurs, the BPPS calibration must be repeated. BPPS calibration must be performed after the BPPS or body control module (BCM) have been serviced. The calibration procedure will set the BPPS home value. This value is used by the BCM to determine the action of the driver applying the brake system and to provide this information to the vehicle subsystems via the serial data communication bus.
Apply the parking brake.
2. Place the transmission in the PARK position for automatic transmission or NEUTRAL for manual transmission.
3. Install a diagnostic scan tool.
4. Key ON, engine OFF, select Body.
5. Select BCM (Body Control Module).
6. Select Programming.
7. Select the Brake Pedal Position Sensor Learn procedure and follow the directions displayed on the screen.
8. Check all vehicle lights for correct operation.
Program SDM Primary Key to BCM
1. Install a diagnostic scan tool.
2. Key ON, engine OFF, select Body.
3. Select BCM (Body Control Module).
4. Select Programming.
5. Select the Program SDM primary key to BCM procedure and follow the directions displayed on the screen.
Perform the Diagnostic Repair Verification Verification Tests after completing the proceeding procedures.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
