Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Caprice PPV V6-3.6LFACTORY OEM SERVICE PROCEDURE
Fuel Level Sensor Replacement - Right Side
Fuel Level Sensor Replacement - Right Side
Removal Procedure
Danger:
To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.
Warning:
Refer to Gasoline/Gasoline Vapors Warning Service Precautions.
Warning:
Refer to Safety Glasses Warning Safety Glasses Warning.
1. Remove the fuel tank assembly from the vehicle. Refer to Fuel Tank Replacement Removal and Replacement.
2. Remove the primary fuel tank module assembly from the fuel tank. Refer to Primary Fuel Tank Module Replacement Primary Fuel Tank Module Replacement.
Note:
Do not damage the retainers (4).
3. Apply suitable pressure to the retainers (4) to release the primary fuel level sensor (3) from the primary fuel tank module (1).
Note:
Do not damage the wiring (2).
4. Detach the wiring (2) from the primary fuel tank module wiring retainers.
5. Lift the primary fuel level sensor (3) upward and detach the fuel level sensor (3) from the primary fuel tank module (1).
6. Disconnect the wiring (2) from the primary fuel level sensor (3).
7. Remove the primary fuel level sensor (3) from the primary fuel tank module (1).
Installation
Note:
Do not damage the wiring (2).
1. Connect the wiring (2) to the primary fuel level sensor (3).
2. Locate and install the primary fuel level sensor (3) to the to the primary fuel tank module (1).
Note:
Listen for an audible click to confirm correct installation of the primary fuel level sensor.
3. Apply suitable downward pressure on the primary fuel level sensor (3).
4. Attach the wiring (2) to the primary fuel tank module wiring retainers.
5. Install the primary fuel tank module assembly to the fuel tank. Refer to Primary Fuel Tank Module Replacement Primary Fuel Tank Module Replacement.
6. Install the fuel tank assembly to the vehicle. Refer to Fuel Tank Replacement Removal and Replacement.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
