Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Caprice PPV V6-3.6LFACTORY OEM SERVICE PROCEDURE
Data Link Connector: Service and Repair
Data Link Resistor Replacement
Removal Procedure
1. Remove the knee bolster. Refer to Knee Bolster Replacement Service and Repair.
2. Remove the front floor console side cover. Refer to Front Floor Console Side Cover Replacement - Right Side (9C3) Front Floor Console Side Cover Replacement - Right Side (9C3)Front Floor Console Side Cover Replacement - Right Side (9C1) Front Floor Console Side Cover Replacement - Right Side (9C1).
3. Remove the instrument panel extension trim panel. Refer to Instrument Panel Lower Extension Side Trim Panel Replacement - Right Side Instrument Panel Lower Extension Side Trim Panel Replacement - Right Side.
4. Remove the tape from the data link resistor (1).
5. Disconnect the data link resistor (1) from the instrument panel harness.
Installation Procedure
1. Connect the data link resistor (1) to the instrument panel harness.
2. Tape the data link resistor (1) to the instrument panel harness.
3. Install the instrument panel extension trim panel. Refer to Instrument Panel Lower Extension Side Trim Panel Replacement - Right Side Instrument Panel Lower Extension Side Trim Panel Replacement - Right Side.
4. Install the front floor console side cover. Refer to Front Floor Console Side Cover Replacement - Right Side (9C3) Front Floor Console Side Cover Replacement - Right Side (9C3)Front Floor Console Side Cover Replacement - Right Side (9C1) Front Floor Console Side Cover Replacement - Right Side (9C1).
5. Install the knee bolster. Refer to Knee Bolster Replacement Service and Repair.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
