Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Caprice PPV V6-3.6LFACTORY OEM SERVICE PROCEDURE
Blower Motor Control Module Replacement (LHD)
Blower Motor Control Module Replacement (LHD)
Removal Procedure
1. Remove the temperature valve actuator-right side. Refer to Temperature Valve Actuator Replacement - Right Side (LHD) Temperature Valve Actuator Replacement - Right Side (LHD).
2. Disconnect the blower motor control processor electrical connector (1).
3. Remove the blower motor control processor to HVAC module assembly retaining screws (4).
4. Remove the blower motor control processor (3) from the HVAC module assembly (2).
Installation Procedure
1. Install the blower motor control processor (3) to the HVAC module assembly (2).
Caution:
Refer to Fastener Caution Fastener Caution.
2. Install the blower motor control processor to HVAC module assembly retaining screws (4) and tighten to 1 Nm (9 lb in).
3. Connect the blower motor control processor electrical connector (1).
4. Install the temperature valve actuator-right side. Refer to Temperature Valve Actuator Replacement - Right Side (LHD) Temperature Valve Actuator Replacement - Right Side (LHD).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
