2012 Chevrolet Caprice PPV V6-3.6LFACTORY OEM SERVICE PROCEDURE

Keyless Entry Receiver: Service and Repair




Remote Control Door Lock Receiver Replacement

Removal Procedure

1. Remove the rear window shelf. Refer to Rear Window Shelf Trim Panel Replacement (Sedan) Rear Window Shelf Trim Panel Replacement (Sedan).

Factory service manual diagram




2. Disconnect the remote function actuator (RFA) (1) electrical connector (2).

Factory service manual diagram




Note:
Removal of the RFA is only accessible through the rear compartment.

3. Remove the RFA by releasing the two retaining tangs (1) and removing it from the rear window shelf.

Installation Procedure

Factory service manual diagram




1. Install the RFA by inserting the retaining tang (1) first and snap fitting the other two retaining tangs (2) listen for an audible click to confirm fitting.

Factory service manual diagram




2. Connect the RFA (1) electrical connector (2).

3. Install the rear window shelf. Refer to Rear Window Shelf Trim Panel Replacement (Sedan) Rear Window Shelf Trim Panel Replacement (Sedan).

4. Program the remote control door lock receiver (1). Refer to Control Module References Control Module References.

5. Operate the keyless entry for correct operation.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.