Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Caprice PPV V6-3.6LFACTORY OEM SERVICE PROCEDURE
Body Control Module: Service and Repair
Body Control Module Replacement
Removal Procedure
1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).
Warning:
Refer to SIR Warning SIR Warning.
2. Disable the SIR system. Refer to SIR Disabling and Enabling Service and Repair.
3. Remove the left floor air outlet duct. Refer to Floor Air Outlet Duct Replacement - Left Side (LHD) Floor Air Outlet Duct Replacement - Left Side (LHD).
4. Disconnect the body control module (BCM) electrical connectors (1) from the BCM (2).
Note:
Release the lower retaining clips (1), lift the BCM and unhook the upper retaining clip (2).
5. Remove the BCM and the bracket assembly (3).
6. Remove the BCM from the bracket.
Installation Procedure
Note:
Locate the upper retaining clip (2) and engage the lower retaining clips (1).
1. Install the BCM and bracket assembly (3).
2. Connect the body control module (BCM) electrical connectors (1) to the BCM (2).
3. Install the left floor air outlet duct. Refer to Floor Air Outlet Duct Replacement - Left Side (LHD) Floor Air Outlet Duct Replacement - Left Side (LHD).
Warning:
Refer to SIR Warning SIR Warning.
4. Enable the SIR system. Refer to SIR Disabling and Enabling Service and Repair.
5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).
6. For programming and set up, refer to Control Module References Control Module References.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
