Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Attach the fuel pump flow control module (1) to the battery tray (3).
- Attach the fuel pump flow control module retainers (4).
- Install the fuel pump flow control module to battery tray underside retaining nut (2) and tighten to 9 N.m (80 lb in).
- Install the battery tray. Refer to Battery Tray Replacement .
- Install the battery. Refer to Battery Replacement .
- Install the left side rear compartment side trim panel access hole cover.
- Remove the suitable liftgate brace from the vehicle.
- Close the liftgate.
Refer to Fastener Caution .
When a suitable hold open device is being removed or installed, provide alternate support.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.