2012 Chevrolet Camaro V6-3.6LFACTORY OEM SERVICE PROCEDURE

Engine Oil: Service and Repair




Engine Oil and Oil Filter Replacement

Removal Procedure

Factory service manual diagram




1. Remove the intake manifold cover (2). Refer to Intake Manifold Cover Replacement - Front Intake Manifold Cover Replacement - Front.

Factory service manual diagram




Note:
Use a 6-point socket to remove the oil filter cap.

2. Place a suitable drain pan below the oil filter adapter (4).

3. Remove the oil filter cap (1).

Note:
It is normal for oil to drain from the oil filter chamber in the oil filter adapter housing. Do NOT replace the oil filter adapter for this condition.

4. Remove and discard the oil filter cartridge (3).

5. Remove and discard the oil filter cap O-ring (2).

6. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

Factory service manual diagram




7. Position the drain pan below the oil drain plug (1).

8. Remove the oil pan drain plug (1).

9. Remove and discard the oil drain plug seal.

10. Allow the oil to drain completely.

Installation Procedure

Factory service manual diagram




Caution:
Refer to Fastener Caution Fastener Caution.

1. Install the oil pan drain plug and NEW drain plug seal and tighten to 25 Nm (18 lb ft).

2. Lower the vehicle.

Factory service manual diagram




Caution:
Lubrication must be applied to the threads of the oil filter cap prior to installation. Failure to lubricate the oil filter cap threads can hinder later removal and cause possible oil filter cap damage.

3. Lubricate the oil filter cap threads and NEW O-ring with clean engine oil.

Factory service manual diagram




Caution:
Proper oil filter cap tightening is mandatory. Failure to tighten the oil filter cap to the proper specification can hinder later removal and cause possible oil filter cap damage.

Note:
Use a 6-point socket to install the oil filter cap.

4. Install a NEW oil filter cartridge (3).

5. Install the oil filter cap (1) and tighten to 25 Nm (18 lb ft).

6. Fill the engine with the appropriate oil type and quantity. Refer to Fluid and Lubricant Recommendations [1][2]Fluid Type Specifications and Approximate Fluid Capacities [1][2]Capacity Specifications.

Factory service manual diagram




7. Install the intake manifold cover (2). Refer to Intake Manifold Cover Replacement - Front Intake Manifold Cover Replacement - Front.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.