Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CAMARO LS, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSHEADLAMP CONTROL MODULE PROGRAMMING AND SETUPCALIBRATION PROCEDURE
2012 Chevrolet Camaro LS, Standard Trans
Calibration Procedure
2012 Chevrolet Camaro LS, Standard TransSECTION Calibration Procedure
- Install a scan tool.
- Clear All DTCs before proceeding.
- Select Module Diagnostics menu item.
- Select Headlamp Control Module menu.
- Select Configuration/Reset Functions menu item.
- Select Automatic Headlamp Leveling Sensor Learn and follow the directions displayed on the screen.
- Once the calibration procedure has been completed, verify the calibration by selecting the calibration procedure on the scan tool an additional time. If mechanical adjustments are required, refer to Headlamp Aiming .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.