Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chevrolet Avalanche 2WD V8-5.3LFACTORY OEM SERVICE PROCEDURE
Left Hand Footwell Components (2 of 2)
Instrument Panel/Center Console Component Views
Left Hand Footwell Components (2 of 2)
1 - I/P Trim
2 - I/P Cluster Trim
3 - Floor Panel
4 - Junction Block - Left I/P
5 - Body Control Module (BCM)
6 - Transfer Case Shift Control Module (NQH)
7 - Fuse Block - I/P
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.