Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chevrolet VoltFACTORY OEM SERVICE PROCEDURE
Section 14 (Lighting System)
WARNING: This page is about a different car, the 2012 Chevrolet Volt. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic Wiring Diagrams
- Diagnostic Information and Procedures
- Diagnostic Code Index
- DTC B096F
- DTC B1395
- DTC B1480
- DTC B2545
- DTC B2570
- DTC B257A
- DTC B2580
- DTC B2585 or B3867
- DTC B2600 or B2605
- DTC B2610
- DTC B2615
- DTC B2625
- DTC B2645
- DTC B3596
- DTC B3600
- DTC B3650
- DTC B3806
- DTC B3881 or B3882
- DTC B3883
- DTC B3884
- DTC B3948 or B3949
- DTC B3950 or B3951
- DTC C0277 or C0890
- DTC C0297
- Symptoms - Lighting
- Backup Lamps Malfunction
- Courtesy Lamps Malfunction
- Daytime Running Lamps Malfunction
- Dome Lamps Malfunction
- Hazard Lamps Malfunction
- Headlamps Malfunction
- Interior Backlighting Malfunction
- Park, License, and/or Tail Lamps Malfunction
- Rear Compartment Lamp Malfunction
- Stop Lamps Malfunction
- Turn Signal Lamps and/or Indicators Malfunction
- Repair Instructions
- Brake Pedal Position Sensor Calibration
- Brake Pedal Position Sensor Replacement
- Reading Lamp Replacement
- Dome and Reading Lamp Replacement
- Dome and Reading Lamp Bulb Replacement
- Sunshade Illuminated Mirror Lamp Bulb Replacement
- Outside Rearview Mirror Turn Signal Lamp Replacement
- Headlamp Replacement
- Headlamp Bulb Replacement
- Headlamp Aiming
- Front Turn Signal Lamp Replacement
- Rear Reflector Replacement
- Front Turn Signal Lamp Bulb Replacement
- High Mount Stop Lamp Replacement
- Cargo Center Courtesy Lamp Bulb Replacement
- Backup Lamp Replacement
- Backup Lamp Bulb Replacement
- Rear License Plate Lamp Replacement
- Rear License Plate Lamp Bulb Replacement
- Tail Lamp Replacement
- Rear Compartment Courtesy Lamp Replacement
- Description and Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.