2011 Chevrolet Traverse LS, FWDFACTORY OEM SERVICE PROCEDURE

Disc Brake Component Specifications

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
General Specifications

Application Specification
Metric English
Front Brakes
  • Brake Pad Friction Material Thickness - Discard
1.40 mm 0.055 in
  • Brake Pad Friction Material Thickness - New
9.50 mm 0.374 in
  • Rotor Minimum Allowable Thickness After Refinish
27.7 mm 1.09 in
  • Rotor Minimum Thickness *
27.5 mm 1.08 in
  • Rotor Thickness - New
29.0 mm 1.14 in
  • Rotor Maximum Allowable Assembled Lateral Runout
0.06 mm 0.002 in
  • Rotor Maximum Allowable Scoring
1.50 mm 0.059 in
  • Rotor Maximum Allowable Thickness Variation
0.025 mm 0.001 in
Rear Brakes
  • Brake Pad Friction Material Thickness - Discard
1.50 mm 0.059 in
  • Brake Pad Friction Material Thickness - New
11.00 mm 0.433 in
  • Rotor Minimum Allowable Thickness After Refinish
18.6 mm 0.73 in
  • Rotor Minimum Thickness *
18.4 mm 0.72 in
  • Rotor Thickness - New
20 mm 0.79 in
  • Rotor Maximum Allowable Assembled Lateral Runout
0.06 mm 0.002 in
  • Rotor Maximum Allowable Scoring
1.50 mm 0.059 in
  • Rotor Maximum Allowable Thickness Variation
0.025 mm 0.001 in
* All brake rotors have a minimum thickness dimension cast into them. Replace any rotor that is worn or machined below this specification.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.