2011 Chevrolet Traverse LS, FWDFACTORY OEM SERVICE PROCEDURE

Fastener Specifications

WARNING: This page is about a different car, the 2015 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
Application Specification
Metric English
Brake Caliper Bleeder Valve- Front and Rear 17 N.m 13 lb ft
Brake Caliper Bracket Bolt- Front 200 N.m 148 lb ft
Brake Caliper Bracket Bolt- Rear 110 N.m 81 lb ft
Brake Caliper Guide Pin Bolt- Front and Rear 60 N.m 44 lb ft
Brake Hose Fitting Bolt- Front and Rear 40 N.m 30 lb ft
Brake Rotor Bolt- Front and Rear 9 N.m 80 lb in
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.