2011 Chevrolet Traverse LS, FWDFACTORY OEM SERVICE PROCEDURE

Accessory and Liftgate Control Module Replacement

WARNING: This page is about a different car, the 2015 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Accessory and Liftgate Control Module
GM2228298Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the rear compartment floor stowage compartment. Refer to Rear Compartment Floor Stowage Compartment Tray Replacement .
1 Accessory and Liftgate Control Module

Procedure

  1. Disconnect the electrical connectors.
  2. Push in tabs to release module from the liftgate pump assembly.
  3. Reprogram the control module if replaced. Refer to Control Module References .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.