Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chevrolet Traverse LS, FWDFACTORY OEM SERVICE PROCEDURE
Component Testing
WARNING: This page is about a different car, the 2015 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
Forward Collision Alert Switch
- Ignition OFF, disconnect the harness connector at the S70L Steering Wheel Controls Switch - Left.
- Test for 7.0k-10.5k Ω between the control terminal 8 and the signal circuit terminal 9.
- If not between 7.0k-10.5k Ω
Replace the S70L Steering Wheel Controls Switch - Left.
- If between 7.0k-10.5k Ω
- If not between 7.0k-10.5k Ω
- Test for 2.1k-3.1k Ω between the control terminal 8 and the signal circuit terminal 9 while pressing the switch.
- If not between 2.1k-3.1k Ω
Replace the S70L Steering Wheel Controls Switch - Left.
- If between 2.1k-3.1k Ω
- If not between 2.1k-3.1k Ω
- All OK.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
