Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chevrolet Traverse LS, FWDFACTORY OEM SERVICE PROCEDURE
Circuit/System Verification
WARNING: This page is about a different car, the 2015 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON.
- Verify there are no DTCs set, except for DTC B101E 4B in the B233B Radar Sensor Module - Long Range or K109 Frontview Camera Module.
- If other DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If no other DTCs are set
Perform the calibration procedure. Refer to Radar Sensor Module - Long Range Calibration .
- If other DTCs are set
- Verify DTC B390C 66 is not set
- If DTC B390C 66 is set
Replace and calibrate the B233B Radar Sensor Module - Long Range.
- If DTC B390C 66 is not set
- If DTC B390C 66 is set
- All OK.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
