Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chevrolet Traverse LS, FWDFACTORY OEM SERVICE PROCEDURE
Circuit/System Testing
WARNING: This page is about a different car, the 2015 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform Circuit/System Verification before beginning Circuit/System Testing.
- Ignition OFF and all vehicle systems OFF. It may take up to 2 min for all vehicle systems to power down.
- Test for less than 10 Ω between the following ground circuit terminals and ground.
- B233LF Radar Sensor Module - Short Range Left Front, terminal 4
- B233RF Radar Sensor Module - Short Range Right Front, terminal 3
- If 10 Ω or greater
- Ignition OFF.
- Test for less than 2 Ω in the appropriate ground circuit end to end.
- If 2 Ω or greater, repair the open/high resistance in the circuit.
- If less than 2 Ω, repair the open/high resistance in the ground connection.
- If less than 10 Ω
- Replace the appropriate B233 Radar Sensor Module - Short Range
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
