Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Verification
- Ignition ON.
- Verify that DTC B3119, B3120, or B3121 is not set.
- If any of the DTCs are setÂ
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If none of the DTCs are setÂ
- If any of the DTCs are setÂ
- Verify that the keyless entry transmitter is correct for the vehicle. This can be accomplished by comparing the part number printed on the transmitter to the appropriate part number in the parts catalog.
- If the keyless entry transmitter is incorrectÂ
Replace the keyless entry transmitter.
- If the keyless entry transmitter is correctÂ
- If the keyless entry transmitter is incorrectÂ
- Verify the scan tool Exterior Driver Door Handle Switch, Exterior Passenger Door Handle Switch, and Trunk Lid Exterior Unlatch Switch parameters change between Active and Inactive while operating their respective exterior door handle/rear closure touch pad.
- If any of the parameters does not changeÂ
Refer to Exterior Door Handle Switch Malfunction .
- If all of the parameters changeÂ
- If any of the parameters does not changeÂ
- Lock the vehicle using the keyless entry transmitter.
- Verify that each door and the rear compartment unlocks and opens by approaching the vehicle with a valid transmitter and operating their respective exterior door handle/rear closure touch pad.
- If both doors and the rear compartment do not unlock/unlatch and openÂ
Refer to Passive Transmitter Malfunction in Circuit/System Testing.
- If only one door or the rear compartment does not unlock/unlatch and openÂ
Refer to Antenna Circuit Malfunction in Circuit/System Testing.
- If both doors and the rear compartment unlocks/unlatches and opensÂ
- If both doors and the rear compartment do not unlock/unlatch and openÂ
- All OK.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
