2011 Chevrolet Traverse LS, AWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Identifying Air Cleaner Components
    GM1860603Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW air cleaner element (4).
  2. Position the air cleaner housing cover (3) (with outlet duct) onto the air cleaner lower housing.
    3. NOTE:

    Ensure the windshield washer hose is routed properly and not trapped between the upper cover and lower housing.

  3. Connect the windshield washer hose clip to the air cleaner housing cover.
  4. Install the air cleaner outlet duct onto the throttle body.
  5. Tighten the 6 air cleaner housing cover screws (2).
    6. CAUTION:

    Refer to Fastener Caution .

  6. Tighten the air cleaner outlet duct clamp (1) at the throttle body.

    Tighten 

    Tighten the clamp to 4 N.m (35 lb in).

    7. Fig 2: Identifying Fresh Air Tube & Related Components
    GM2065375Courtesy of GENERAL MOTORS CORP.
  7. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
  8. Connect the PCV quick disconnect (2). Refer to Plastic Collar Quick Connect Fitting Service .
  9. Install the fuel injector sight shield. Refer to FUEL INJECTOR SIGHT SHIELD REPLACEMENT .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.