Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chevrolet Traverse LS, AWDFACTORY OEM SERVICE PROCEDURE
Interior HVAC Module- Front (CJ2)
Interior HVAC Module- Front (CJ2)
| Component Name | Callout |
|---|---|
| Air Temperature Sensor- Upper Left | 1 |
| Air Temperature Actuator- Left | 2 |
| Air Temperature Sensor- Lower Right | 3 |
| Air Temperature Actuator- Right | 4 |
| Mode Actuator | 5 |
| Air Temperature Sensor- Upper Right | 6 |
| Blower Motor | 7 |
| Blower Motor Control Module | 8 |
| Evaporator Temperature Sensor | 9 |
| Air Temperature Sensor- Lower Left | 10 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.