2011 Chevrolet Impala LTZFACTORY OEM SERVICE PROCEDURE

Installation Procedure

NOTE: DO NOT reuse the throttle body gasket. Install a NEW gasket during assembly.
    Fig 1: Identifying Throttle Body, Throttle Body Seal & Intake Manifold
    GM1608805Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW throttle body gasket. Align the locating tab of the gasket with the notch in the manifold.
  2. Position the throttle body to the intake manifold.
  3. CAUTION: Refer to Fastener Caution .
  4. Install the throttle body bolts and tighten to 10 N.m (89 lb in).
  5. Fig 2: Coolant Inlet And Outlet Hoses/Pipes
    GM1608325Courtesy of GENERAL MOTORS CORP.
  6. Position the heater inlet and outlet hose/pipe.
  7. Position the heater inlet and outlet hose clamps at the engine pipes.
  8. Install the heater inlet and outlet pipe clip nuts to the throttle body studs and tighten to 10 N.m (89 lb in).
  9. Fig 3: View Of EVAP Canister Purge Solenoid Electrical Connector
    GM1608290Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.