2011 Chevrolet HHR LS, StandardFACTORY OEM SERVICE PROCEDURE

Inside Center Console Components

Inside Center Console Components

Component Name Callout
Instrument Panel Trim 1
Body Control Module (BCM) 2
Inflatable Restraint Vehicle Rollover Sensor 3
Automatic Transmission Shift Lever (MN5) 4
Yaw and Lateral Accelerometer Sensor (JL4) 5
Floor Panel 6
Park Brake Switch 7
Inflatable Restraint Sensing and Diagnostic Module (SDM) 8
Fig 1: Center Console Components
GM2193370Courtesy of GENERAL MOTORS COMPANY
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.