2011 Chevrolet HHR LS, AutomaticFACTORY OEM SERVICE PROCEDURE

Communication Interface Module Battery Replacement

Fig 1: Communication Interface Module Battery
GM1614248Courtesy of GENERAL MOTORS COMPANY
Communication Interface Module Battery Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the rear seat. Refer to Rear Seat Replacement .
  2. Remove the right rear quarter lower trim panel. Refer to Quarter Lower Rear Trim Panel Replacement .
1 Communication Interface Module Battery Nut (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Communication Interface Module Battery
TIP:  Disconnect the electrical connector.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.