Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chevrolet Cruze LTZFACTORY OEM SERVICE PROCEDURE
Immobilizer System Diagnostic Code Index
IMMOBILIZER SYSTEM DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| DTC B2955 | B2955 00: Security Sensor Data Circuit |
| DTC B3006 | B3006 01: Hood Ajar Circuit Short to Battery B3006 02: Hood Ajar Circuit Short to Ground B3006 04: Hood Ajar Circuit Open |
| DTC B302A | B302A 00: Mobile Telephone Communications Interface Requested Immobilization Malfunction |
| DTC B3031 | B3031 00: Security Controller In Learn Mode Malfunction |
| DTC B3055 | B3055 00: No Transponder Modulation or No Transponder |
| DTC B3060 | B3060 00: Unprogrammed Transponder Identification Code Received Malfunction |
| DTC B389A | B389A 00: Environment Identification |
| DTC B3902 | B3902 00: Incorrect Immobilizer Identifier Received |
| DTC B3935 | B3935 00: Transponder Authentication Error |
| DTC B3976 | B3976 00: Unconfigured Transponder |
| DTC B3984 | B3984 00: Device 1 Environment Identifier Not Programmable |
| DTC P0513 | P0513: Immobilizer Key Incorrect |
| DTC P0633 | P0633: Immobilizer Key Not Programmed |
| DTC P162B | P162B: Remote Vehicle Speed Limiting Signal Message Counter Incorrect |
| DTC P1631 | P1631: Immobilizer Fuel Enable Signal Not Correct |
| DTC P1649 | P1649: Immobilizer Security Code Not Programmed |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
